1. Snap open along the inner radius with integral hinges (at the inner radius) 2. Small pitch for quiet, smooth run 3. Mounting bracket with integrated strain relief 4. Dirt-resistant outer contour 5. Two-piece, small e-chain® with large inner height 6. Small bending radius 7. Nice design 8. Closed outside
* The required clearance height is HF = H + 30 mm (for 0,5 kg/m additional load) We request you to consult in case of especially restricted space ratios.
** The calculated length corresponds to the chain length without mounting brackets.
A=Moving end, B=Fixed endPitch: 30,5 mLinks per m: 33Travel: SChain lenght = S/2 + K
The unsupported length is dependent on the additional load X-axis: Unsupported length in m FLB/FLG Y-axis Additional load in kg/m Lower scale: Travel S in m FLB = unsupported with permitted sag FLG = unsupported with straight upper run Reference example A:
Fill weight = 0,75 [kg/m]
Unsupported length FLB = 0,8 m
Travel = 1,6 m
Samples and catalog order
E-Chain® Expert call
Service life calculation
Ask the product expert
Designing with igus®
Other installation types
Variant 1: Standard
Version 1: Standard Separators can be arranged at any position in the chain cross-section to divide the interior of the e-chain®. Per standard, separators are mounted on every 2nd chain link!
Slotted separator R171 Vertical separation in e-chains®. It can be used additionally for simple vertical/horizontal divisions due to its notches.
Full-width shelf 110.X
Recommended if many thin cables with similar
or the same diameters are used. or integrated subdivision Push-in shelves can be arranged within the entire chain width of 5 mm (in 5 levels).
Polymer - locking
117.1.12.P(Z) :only centre holes117.2.12.P(Z) - 117.7.12.P(Z) : Only outer holes
Data protection declaration