1./2. Double stop dog3. Wide area for cable4. Glide runners5. Full surface pins6. Flip open crossbar (Series 35)
For new constructions, we recommend the technically improved e-chain® series 3500 from the igus® E2/000 range.Secure hold of the crossbars, improved opening system, greater unsupported lengths and same dimensions Series 35 is available in limited quantities ex stock. Product support and storage will be restricted from 2012. For any questions, please contact your igus® contact. Thank you for your understanding
to the E2/000 Series 3500
* The required clearance height is HF = H + 40 mm (at 2,5 kg/m additional load), this should be observed for all types of applications.Please consult igus® if space is particurlarly restricted.
** The calculated length corresponds to the chain length without mounting brackets.
A= Moving end, B= Fixed endPitch: 67 mmlinks per m: 15travel: SChain length = S/2 + K
The unsupported length is dependent on the additional load X-axis: Unsupported length in m FLB/FLG Y-axis Additional load in kg/m Lower scale: Travel S in m FLB = unsupported with permitted sag FLG = unsupported with straight upper run
Samples and catalog order
E-Chain® Expert call
Service life calculation
Ask the product expert
Designing with igus®
Design specificationFurther information on "unsupported application"
Design specificationFurther information on "gliding application"
Other installation types
Option 1 - Separators
Option 2 - Full-width shelves
The interior separation system of the series 30/35/36: Variant 1 Separators: Separators: Can be used freely, can be shifted
Separators are an option to partition the interior of flip-open chains of the type 35/36 (only way for the internal separation of the Series 30) and are used mainly for side-mounted chains.
Option 2: Full-width shelves and separators
This option is only available for snap-open 240/250 chains. It is expedient when using multiple thin cables with similar or identical diameters. These versions fill the entire inner width of the chain.
Option 1, steel, one-piece
Option 2, steel, two-piece
Option 2: Steel, one-piece
Option 1: Steel
Steel guide troughs
1. Guide trough (blue)2. Gliding rail (black)3. Assembly kit (red)4. Individual fastening without C profile5. Length of rail profile
+ Simple assembly due to assembly kits+ 2 piece design - adjustable to chain width+ very rugged+ cost-effective+ wide selection
Guide trough without gliding rails Part No. 93.30, guide trough with gliding rails Part No. 93.31
Assembly sets as butt joint part no. 93.50. XX
Data protection declaration